When the small road roller is working, due to various small problems, the leakage of the hydraulic system is one of them. Next, I will briefly talk about this point. It is mainly about the solution steps and methods of leakage, I hope it can help you!
1. Turn off the key or remove the key to prevent the engine from starting.
2. Let the engine idle for 5-10 seconds to allow hydraulic oil to enter the line.
3. Put the front and rear operating levers to the neutral position, start the engine and rotate for 3-4 minutes under no-load conditions.
4. With the engine running at no load, slowly move the joystick forward and backward to make the machine forward and backward for a short time to discharge the gas in the drive system.
5. Increase the engine speed and operate all control parts to discharge the residual gas in the hydraulic system.
6. Check the hydraulic oil level and add hydraulic oil as required.
