I. Temporary Fault Handling
Restart Operation: Start and stop the engine three times consecutively. Some ECUs will clear temporary fault codes.
Power-Off Reset: Disconnect the negative terminal of the battery for more than 30 seconds to clear the fault codes in the memory.
Note: This may reset electronic equipment parameters.
II. Permanent Fault Handling
Professional Diagnosis: Use an OBD device to read the fault codes and perform targeted repairs.
Recommended Equipment: Bluetooth diagnostic tool (approximately tens of yuan)
Post-Repair Clearing: After the fault is repaired, the diagnostic program will automatically clear the codes.
III. Precautions
Yellow fault light requires checking oil pressure/water temperature.
Red fault light requires immediate shutdown and repair.
Recurring faults require professional troubleshooting.
