Wuxi Mr Hippo Machinery Co., Ltd.

How to test the water spray nozzles on a road roller after adjustment?

Jan 28, 2026

I. Basic Testing in Three Steps

1. Start-up Test: Turn on the road roller power and press the water spray button to observe the water flow point. Ideally, the highest point of the water jet should reach two-thirds of the windshield, covering the wiper working area.

2. Dynamic Verification: Spray water three times consecutively and check for any blind spots. If uneven spraying is found, immediately unclog the water spray nozzles.

3. Angle Fine-tuning: Use a fine needle or flathead screwdriver to adjust the angle of the water spray nozzles, no more than 15 degrees at a time, until even coverage is achieved.

II. Key Indicator Checks

Water Flow: The water flow must be a mist; excessive flow is strictly prohibited to prevent the mixture from cooling too quickly.

Anti-sticking Agent: Use a dedicated anti-sticking agent (such as water or a dedicated emulsifier). Diesel or gasoline is strictly prohibited.

III. Precautions

Force Control: Adjust the force gently to avoid damaging the internal structure of the water spray nozzles. Regular inspection: Check the spray nozzles monthly for blockages or leaks to ensure the equipment is operating normally.

Twin Drum Compaction Roller

goTop