Wuxi Mr Hippo Machinery Co., Ltd.

Road Roller operating requirements

Apr 05, 2024

1. Preparation before homework
Check whether all working mechanisms and fastening parts are intact. Start the engine and confirm it is normal through test operation, and the braking, steering and other working mechanisms should be intact. Use the method of increasing or decreasing the counterweight to adjust the pressure of the Road Roller operation line to the specified value. However, for initial pressure operations on soft roadbeds and near mountains and steep areas, the construction site must be inspected to ensure the safety of the workers.
2. Requirements in homework
During operation, the operator should follow the compaction process specified in the construction regulations for rolling. During the operation, pay close attention to the readings of each instrument. If any abnormalities are found, they should be checked and eliminated in time. It is strictly forbidden to work while sick. The amplitude and frequency of the vibratory roller should be controlled within the specified range. Vibratory rollers should stop vibrating before changing direction, slowing down or stopping. When multiple Road Rollers work together, they should maintain the prescribed formation and separation distance, and establish corresponding contact signals. The Road Roller should be turned and changed smoothly during the rolling section, and the Road Roller should not be allowed to change direction in the inertial rolling state. Operate according to the prescribed rolling speed, and do not change the rolling speed and direction at will or stop the machine midway. It is forbidden to use the differential locking device on three-wheel rollers under normal circumstances, especially when turning. It is forbidden to change gears when the roller is driving on a slope, and it is forbidden to slide out of gear. It is strictly prohibited for the Road Roller to tow other equipment or be towed, and it is strictly prohibited for the Road Roller to move by itself over long distances.
3. Post-work requirements
After operation, the Road Roller should be parked on a safe and flat site. After each shift is completed, the dirt on the entire machine and the surface of the grinding wheel should be cleaned promptly, and routine maintenance work should be performed according to regulations and time.

goTop