1. Insufficient preparation before operation
Failure to read the operation manual carefully: The operator did not read the operation manual carefully and was not familiar with the equipment performance and operating limitations.
Failure to check the equipment status: Failure to check the equipment's braking system, tire pressure, lubricating oil and fuel level, etc., may cause equipment failure.
2. Errors during operation
Sudden acceleration and sudden braking: Lead to uneven compaction of materials and equipment wear.
Improper adjustment of vibration frequency: The vibration frequency is not adjusted according to construction requirements, affecting the compaction effect.
Vibration on solid ground: It is strictly forbidden to vibrate on solid ground to avoid damage to the equipment.
Overload operation: Long-term high-load operation may cause overheating or damage to the equipment.
Operator fatigue driving: Long-term operation leads to fatigue, affecting operational safety.
3. Neglect of safety precautions
Failure to wear safety equipment: The operator did not wear necessary safety equipment such as safety helmets and safety shoes.
Failure to pay attention to the surrounding environment: Failure to pay attention to the surrounding environment and personnel during operation may cause collisions or accidents.
Failure to comply with traffic rules: Failure to comply with traffic rules while driving on the road may result in traffic accidents.
Failure to use the three-point handlebars: Failure to use the three-point handlebars when getting on and off the vehicle may result in slips or falls.
4. Negligence in maintenance
Failure to inspect the equipment regularly: Failure to inspect the various components of the equipment regularly may result in potential problems not being discovered in time.
Failure to replace the lubricant in time: Failure to replace the lubricant in time may result in equipment wear.
Failure to clean the equipment: Failure to clean the dirt and debris on the surface of the equipment in time may result in rust on the equipment.
5. Other wrong behaviors
Crossing on a slope: Avoid crossing on a sloped road surface and drive in the direction of the slope.
Failure to install a rollover protection device: Failure to install a rollover protection device when working on a dangerous road surface.
Failure to use protective equipment: Failure to use the provided protective equipment during operation.
