Small road rollers are a very common mechanical equipment now, and they play a very important role for us. We are also very concerned about fuel consumption. Can we take some measures to reduce fuel consumption? So what should we do? Today I will give you a brief introduction.
1. Maintain the normal working temperature of the engine, especially in the cold season, try to keep the water temperature at 75-90℃, and use the oil according to the season. Regularly remove the scale of the cooling system and the grease and deposits of the pipes and mufflers. Adjust the brakes correctly, check the front and rear wheels of the tractor frequently, and keep the tire pressure normal. Do not run the engine at idle speed for a long time, stop the engine immediately.
2. Start slowly. During the starting process, the roller should start at low gear, gently step on the accelerator, and slowly increase the speed. Don't slam on the accelerator all at once, slamming on the accelerator will double the fuel consumption. The starting method of lightly stepping on the accelerator can not only shorten the heating time of the engine but also effectively improve the fuel utilization rate, thereby achieving the effect of saving fuel.
3. Select an appropriate driving speed, do not slam the accelerator, and do not speed. Appropriately plan fields and driving routes, minimize idling, empty driving, detours, and stop in the middle, shorten the total travel distance of operations, and reduce ineffective energy consumption. Carry out technical maintenance in a timely and reasonable manner, keep all components and mechanisms in good technical condition, and operate without illness.
4. It is also necessary to replace the three filters on a regular basis. During the use of the vehicle, if the oil filter, air filter, and gasoline filter are not replaced for a long time, they will become dirty and greasy, affecting the use, and giving the engine The control unit transmits wrong information, resulting in insufficient fuel combustion and increased engine carbon deposits.
5. In order to prevent the impurities in the oil from harming the roller, the editor recommends that the oil should be precipitated for more than 48 hours before use. In addition, after the machine is used for a long time, there will be poor contact between the connecting parts, improper assembly, damage to the cushion, loose screws, deformation or rupture of the conduit, and aging of the sealing ring, all of which will cause oil leakage. Therefore, corresponding countermeasures must be taken to stop leakage and save fuel time.
