-
Jan 072026What are the operating techniques for a road roller?
I. Basic Operation Starting and Driving: First, check the instruments. After confirming they are normal, engage a low gear and smoothly push the rever
-
Jan 052026What are some common tamping rammer malfunctions?
I. Hydraulic System Malfunctions 1. Pipe joint leakage: Often caused by vibration or improper installation; tighten or replace seals. 2. Unstable tamp
-
Jan 022026How to Properly Operate a Tamping Rammer?
I. Pre-Operation Preparation Equipment Inspection: Confirm engine oil and hydraulic oil levels are normal. Check that all connections are secure and t
-
Dec 312025How to determine if a plate compactor needs major repair?
I. Deterioration of Key Performance Weakened excitation force: Compaction effect is significantly worse, requiring repeated compaction to achieve the
-
Dec 292025How to determine if a plate compactor is working properly?
I. Lubricating Oil Level Check 1. Oil Level Standard: Confirm the oil level is between the "MIN" and "MAX" marks using the dipstic
-
Dec 262025How to Properly Operate a Plate Compactor?
I. Pre-Operation Preparation 1. Environmental Inspection: Clear debris and gravel from the work area, ensuring the ground slope is ≤15°. Equipm
-
Dec 242025How to adjust the roller speed according to the construction stage?
I. Initial Compaction Stage Speed Range: 8-10 km/h (impact roller) or 1.5-2 km/h (steel wheel static roller) Function: To break down the soil struct
-
Dec 222025How to Determine if a Road Roller Speed is Appropriate
I. Speed Control Based on Construction Stage Initial Compaction Stage: Use static compaction, controlling the speed at 1.5-2.5 km/h (1.5-1.7 km/h fo
-
Dec 192025How to manually clear fault codes on a road roller?
Restart Operation Park the road roller on a level surface, ensuring safety. Turn off the engine and wait approximately 30 seconds. Restart the engine
-
Dec 172025How to determine if a road roller's fault codes have been cleared?
1. Observe the fault light status. If the fault light is off, the code may have been cleared. However, note that some fault lights may still illuminat
-
Dec 152025How to clear fault codes on a road roller?
I. Temporary Fault Handling Restart Operation: Start and stop the engine three times consecutively. Some ECUs will clear temporary fault codes. Power-
-
Dec 122025What are some common road roller malfunctions?
I. Abnormal Oil Level Insufficient/Contaminated Hydraulic Oil: Causes insufficient system pressure and abnormal vibration frequency. Check the oil lev
